Farmall & IHC Tractors Discussion Board |
Need help removing of counter shaft oil seals on my H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Neal (TX) on January 19, 2001 at 19:57:47 from (152.163.204.204):
Does anyone know the proper technique for removing and replacing countershaft and main transmission/clutch shaft oil seals? Here's the story: I filled up my differential with diesel fuel to flush out the junk. Diesel started pouring out of the transmission case via the countershaft oil seal and main shaft oil seal. I removed the countershaft coupling which then exposed the coupling jaws on the power unit and transmission case. My parts manual shows that the coupling jaws are threaded on the shaft. Since the outside diameter is larger than the oil seals, it appears that the jaws must come off. I put a set of channel locks on the coupling jaw nearest the transmission case on the countershaft and tried to rotate counter-clockwise with no luck. Then I tried a pipewrench and nothing. Lastly I tried tapping the pipewrench with a rubber mallet, and still no luck. Therefore, to prevent damaging the transmission gears, I thought I would stop and see if anyone had any suggestions. Please help! Thanks: Neal Kingwood, Texas
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|