Farmall & IHC Tractors Discussion Board |
Re: Farmall cub Governors
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on January 24, 2001 at 09:18:57 from (205.215.115.135):
In Reply to: Farmall cub Governors posted by George on January 23, 2001 at 15:43:39:
George, There are three adjustments to the governor. First, set the throttle linkage length correctly. Disconnect the throttle linkage clevis from the governor rockshaft. Place the throttle lever in wide open position and open the throttle on the carb all the way. The clevis and the rock shaft need to line up. If they don't adjust the length of the throttle linkage by turning the clevis (if it isn't rusted stuck) till the holes line up. Two, the screw on top of the governor is the high speed stop. This controls how forward you can push the throttle lever, and thus how much tension you can place on the spring. Should be no need to goof with this. Three, the little screw at the front of the governor is a surge adjustment. If your Cub is constantly sruging in throttle like it's looking for the right speed, turn this in just till the surging goes away. Hope this is a little clearer than mud. Good luck, Chris
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|