Posted by Janicholson on September 05, 2011 at 08:52:13 from (199.17.6.77):
In Reply to: Balast compensation posted by Welsarth on September 04, 2011 at 23:18:48:
A great question. Ballasting to limit depth change oscillations might be difficult. I would argue for a more direct solution that allowed stronger traction equalization. That is to use a gauge wheel on the rear plow to force the depth to remain constant. (could be front as well, or only) Plow shares address the soil with a cutting edge. as it wears, the suction of the moldboard changes. Soil conditions (even across the distance between front and rear can also affect the depth and suction across the entire unit. Gauge wheels would be set to just graze the undisturbed earth. My rationale is that construction equipment and leveling devices often use depth gauge wheels to stabelize cut settings. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.