Dave , A cross reference sould be available from a parts store. If not. I'll research it for ya. Now a helpful bit of information. When you get the plug, use a volt ohm meter(set to continuity)put prong on treaded side, other point in cable to the electrode (center of the plug with out touching the pointer on the threaded side.) look at the resistance reading different from plug to plug.We place the lowest resistor reading to the farthest plug from the distributor.Current flow is stronger and better for each cylinder. We have found(NEW PLUGS) that showed nothing. Bad plugs from factory source. Parts store couldn't believe it ,even when they took one from the shelf to check. we clean and re-gap a lot of plugs and re-check em with the meter, Saves a lot of dough. Only thing after cleaning em is to BLOW OUT THE PLUG so no sand gets deposited ed in the engine.HTH Regards LOU.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.