If you are going to burn wood, and I would say from looking at your pictures, that would be the way to go. By having the firebrick in there it forces the fire closer to the pan bottom, thus getting a better boil. My commercial evaporator is set up much the same way, but I also fill it nearly up to the pan bottom with sand so that the fire runs closer yet to the pan. My back pan (flue pan) is what they call a raised flue pan,the botton is grossly corragated, the corrugations being about 8 incheds deep. this gives the pan bottom a lot more surface area exposed to the heat. (Irrelevant to your questions) The small pan/ compartment would be in the front, i.e., closest to the door. this will be cooler than at the back where the stack is. I think you will have fun with it! The other thing to do is to run at least a 6 inch stack and at least 10 feet tall. This gives a much better draft, thus a hotter fire but be prepared to really put the wood to 'er. Really, really dry wood is important also and there is nothing wrong with pine. I try to use pine whenever I can and prefer it. I dont see in the pictures but is there a draw-off valve on the small front pan so you can draw the finished syrup off? That way you won't have to be bailing it. ....Good sugaring! Cal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.