soil type,how deep frost goes etc.all play a part in proper anchor/brace post. My Dad spent a good part of his life fenceing,and he would cringe at the mention of cementing in a post.Whenever possible we would "stone" in the posts.Just field stone that was picked off of any worked fields.Dad always said no dirt around post or it would rot off. The stones allow good drainage. For anchor posts we would dig hole big enuff to allow for a "foot" to be installed on the bottom of same. This was usualy done by notching near bottom of post, and driving a chunk of cedar rail into the v notch tight.If I remember right sometimes he would put this cross rail into both sides , I am guessing if size of anchor post would allow it? Posts of course always had to be deeper than the anticipated frost. From brace post a diagonal pole was slightly mortised into it and anchor post, then the hvy brace wire put on and twisted tight on the oppisite diagonal. This worked well on farms where you could actualy dig a hole, but on His ranchland limestone was close to the surface in fact someplaces it was the surface! Whole new ball game! Good brace posts where made by making a crib out of poles about 5 ft.square and filling it with rocks. Very labour intensive. I guess that is why there are so many crooked rail fences in that part of our country? Sorry I probably didnt answer much of what you asked. But thank you for allowing me to reminise about the good old days with my Dad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.