Without knowing the actual full load amps of that motor I will have to venture a somewhat educated GUESS:
If the 5 HP single phase AC motor draws say 28 amps at full load,,,,,,,,,that would require a MINIMUM of 8 gauge (40 amp rated) copper wire and you could "get by" with that.
HOWEVER to reduce the voltage drop over 70 feet of conductors Id probably go one size bigger and use 6 gauge.
If its a straight 230 volt motor load with NOOOOOO 120 volt required, that means you can run 3 conductors:
If I were designing and specifying the job (like I used to do but long since retired) there at the motor (within sight and 50 feet at minimum but I prefer right near the motor) I would place a "method of disconnection" which at the bare MINIMUM could be a plug and cord from the motor connected into a 2 pole 3 wire grounding outlet and Id prefer a twist lock.
HOWEVER my preference would be EITHER a 2 pole knife blade type "Safety switch" or better a 2 pole "fused safety switch" equipped with dual element Class K5 time delay fuses or IFFFFFFFFFF the motor isnt equipped with thermal overload protection then a "combination starter" which is BOTH a safety switch PLUS a thermal overload protection device (with appropriate sized heaters/thermals/overloads)
NOTE The motor should have thermal overload protection, either built in but if not then as noted above.
NOTE you should use flexible conduit or rubber cord from the motor to the means of disconnection
NOTE if you use 6 gauge wire and a 50 amp 240 volt 2 pole circuit breaker as the motors branch circuit feed out of the panel and it doesnt allow the motor to start???? (may well do it) you can use a bigger breaker if necessary which wont trip due the the initial higher inrush starting current
DISCLAIMER Ive been retired from engineering for yearssssssssss and am rusty on this and the latest NEC so if more current professional electricians or engineers need to add to or correct this PLEASE DO SO
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.