Posted by Texasmark1 on July 05, 2012 at 13:08:21 from (67.142.164.20):
In Reply to: Re: 4020 cranking posted by martye on July 05, 2012 at 07:48:43:
I've had a lot of tractors and I am a senior citizen....memory thing. I have had a 4020 with the 24 volt system and a 4010 with the 12v system, 4230 12v system, along with half dozen Fords, MF's, IH products, and who knows what all.
My comment was made from my memory of my 4020 24 volt system and I had that tractor like 20 years ago. I am remembering a very complicated switch, diameter of which was larger than a silver dollar, that had + and - 12v inputs (the way the 24v system was setup....+12v to -12v = 24v....that is why I associated it with my 4020. I do not remember if it started with a button or just turning the switch to start...just don't remember. I have some Fords that had both and remember the MF was key start. Don't remember on the IH. I was of the impression that it was the latter.....key start on the 4020.
You are not talking about rocket science. Heat is making a conducting path somewhere for voltage to get to your starter solenoid energizing coil in a sufficient amount that it can close the contacts and spin your starter. There is a path and heat has something to do with it.
Tell you what. Next time you start your tractor, remove the hot small wire from the starting solenoid after you get it started. If you need to restart it, touch the wire to the terminal, get it running and remove it. See if it self starts under that condition.
I'm not there so this is the best that I can do from here.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.