Posted by jon f mn on July 07, 2012 at 11:04:25 from (166.249.130.123):
In Reply to: OT Fishing Dock posted by Heyseed on July 07, 2012 at 09:05:55:
Going to make it out of wood or steel? When I did them out of steel I would use a 1 1/2 inch pipe welded to a used disc blade for the legs. Run the pipe through a 2 inch pipe with a set screw in it so you could slide it up and down with the water and as the disc blade settled into the muck. The longest one I did ran 300 ft through a swamp to the lake edge because the DNR wouldn't let the guy dredge it. It's still there after 15 years. You could do 30 ft with only 2 or 4 legs easily. We made them in 20 ft sections because the angle comes in 20 ft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.