Posted by cranny672 on December 20, 2012 at 13:01:53 from (212.248.165.150):
ISSUE: Massey 35 4 cylinder/ FE35 4 cylinder 23C Engine Low oil pressure problem. Hello there, basically the problem is 15-20psi when moving or been run for a while, eg got warm, I have asked many people about this and no one has really come to a conclusion, just wondered if anyone else had a similar problem or better knowledge. Firstly I changed conrod bearings as the pressure was low, also checked all clearances on oil pump- all okay. The crank has previously been reground and when the conrod bearing were removed they had little wear on them, proving it has rebuilt fairly recently, the head has also been removed and the liners have no lip at all. I’ve also had an oil change to 15w40 and when I did this I had 120psi when started up- when the pressure release valve was screwed all the way in then I adjusted it down to 60 at full revs (what it should be). Though I started it the other day and the pressure never really got over 40 (the same situation as I had before I even touched the engine), then when it was moved (got warm) it dropped to 15-20psi, then fiddled with the pressure release valve and this didn’t really change it. The recommended is 40-60 psi dependant on the revs. The pressure has been measured with a mechanics pressure gauge which is very accurate and tested so that is not at fault. I don’t wish to replace the main bearings as this means dismantling the whole engine down to the block and removing the crank, and considering the conrod bearing had little wear and the crank has been reground this suggests the main bearing shouldn’t be the issue, even though these don’t usually wear as much as the conrod bearings.
Just wondered if anyone had any ideas or suggestions on how to solve this problem! Many thanks Rob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.