What you would need for that tractor is what Ferguson called a tiller built from I believe 1939 for the 9N ford but may have been built earlier for the Fordson. 9 shank is 7' wide and most popular, they used the same frame as the 2 row cultivators. That will put a load on your Ford but they were made to work with the 23 HP 9N and yours is a 37 HP tractor. There also was a Dearborn version sold and I think an aftermarket company still makes a version of it. But you can only in no trash situations run about 7" deep at maximun due to frame clearance. You could run a spike type of tooth but you could also put on a sweep from a John Deere CC series field cultivator (the only one with matching holes). Like in the picture of that Ferguson unit would work good but have never seen one but I have the tiller version. And it did give me a load with a 60HP (tested) Ford 4000 tractor. That Ford would only pull a 5 shank chisel 3 point mounter set on 12" shank spacing and covering only a 5' width. Pulled 7 shanks with a 5000 but that was not in hard ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.