Posted by johndeerefan on June 26, 2013 at 07:58:41 from (75.146.9.13):
In Reply to: Cattle working setup posted by Sparktrician on June 25, 2013 at 08:00:21:
We use the adjustable WW Livestock panels that adjust in width. We have a series of holding pens with gates at each end, then the lane panels at the end of the last pen. The last pen is funneled down to the max lane panel width. The idea is to have the back panels attached to your holding pen at the widest they will go and narrow the lane width as you get closer to the head catcher. We have the WW spring loaded stop bars, but they are kinda a headache. Just sliding a simple 2x4 or steel pipe at each panel in behind them as they move forward seems to work the best. Sometimes the smaller calves aren't strong enough to push the spring loaded bar forward. Our WW head catcher is actually inside a holding pen that is attached to the first holding pen so that if one did happen to get through without being caught, we could open the gate and run it back through the series of pens again instead of it going out into open pasture. We also have a 12V set of scales in the lane at the last panel before the head catcher.
We have modified a few things along the way, but now we have it to where one person can work the cattle or weigh them and load them in the trailer.
The main thing is to make the lane narrow so they can't get turned around once started down it
The WW sweeper tub setup is top notch, but you will pay for it.
This post was edited by johndeerefan at 08:00:30 06/26/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
