Posted by Stick welding on October 29, 2013 at 22:36:01 from (96.53.210.246):
In Reply to: Mustang skidsteer posted by mnjoe on October 29, 2013 at 20:06:49:
If it's from the mid 90's I'd avoid it! In general Mustang are good skid steers but the small ones from that era were WAY under powered. I rented one to do a job in very tight quarters and down a 4' retaining wall. One thing I don't like about Mustangs is that the hydraulic tank is in the belly of the machine. It didn't have enough power to back up the ramps to get out of the hole! It ended up tipping forward on the bucket when I tried to take a little(12") run to get up the ramps. Now I had a scary situation. The bucket was raised about 1/2 way so it wouldn't drag on the ground when I started up the ramps. I couldn't lower the boom to put the machine back on all fours because it was starved for oil. I had no other choice but to crawl out of the machine when it was tipped forward. I had to use all my chains a couple boomers hooked to a tree to right it. Mustang used to have their own style single pin quick attach that nothing else fit. I would also suggest going up a size to a 1000 or preferably a 1300 lb. rated capacity skid steer. Much more stable and will do a ton more work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.