Posted by CAS on July 16, 2014 at 21:17:59 from (67.240.133.144):
In Reply to: engine honing posted by Nick167 on July 16, 2014 at 19:01:02:
Everbody says they can hone engine cylinders. It is not hard if you have the right hone. For what you are doing I would use a ball hone and variable speed drill. GOODSON is a large supplier of quality engine machining supplies. They have a good website and product discription and prices. Intake valves all turning is a little puzzling. Do you have the valve springs off. Intakes usually do not burn. But, the exhaust valves more than make up as far as having burn marks and leaking. I look up some utube videos and watch them. If you do not find enough good ones email me. Richard G mentioned do it right. Part of that is learning all you can for the job you are going to do. And, do not rush it too much.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.