Posted by dustycoal on October 04, 2015 at 05:32:36 from (74.229.201.151):
In Reply to: Tire balancing posted by notjustair on October 03, 2015 at 10:14:39:
I would match mount the tire using the white or colored dot on the tire to the valve stem. Large truck rims have a punch mark sometimes showing you the heaviest place on the rim. Most of the time they almost always don't need any weights. Most good tires have the dots painted on them. Also if it takes a lot of weights you should deflate tire and rotate on the rim 180 and see if it balances better. Most times it will. I have found some cheaper tires just don't balance at all and have sent them back to the dealer or used on a trailer somewhere. Most tire store don't school their help on the right way to mount and balance tires. Ask the person if he knows how to match mount your tire, If he doesn't know ask him to try it, May save you problems and teach him a new way of doing it. I'm retired from a large truck leasing company, Had over 500 units we maintained just at our location, Lot of tires. Company sent us to tire school every couple years. Tires are your second expense under fuel cost.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.