I have a vent free wall mounted heater in the living room of this house. We use it all of the time ion the winter. It provides a large part of our heat. It does put moisture into the air but with the furnace drying the air out the extra moisture is needed. We noticed fewer cracked hands and nose bleeds from dry noses.
Now this house is far from air tight and that is one of the reasons I went with a vent free heater. There is enough leaks for there to keep the in side air in good condition. Also this heater is entirely propane. It does not need electric for anything. If we do not have electric this heater will easily keep the house warm enough that the pipes are safe.
With all of that I would recommend a vented heater for your house as it is much more air tight. I installed one in my Mother-in-laws 25 years ago. She did exactly what your wanting to do. She kept the furnace set on 60 and used the propane fire place to keep the living room and kitchen 72 degrees. She liked sleeping in a cooler bedroom, I do as well.
Look for a heater in the 25-30K Btu. range. You should be able to find them that are setup for more of a primary heat source. Forget the fireplace sales store stuff. They mainly have smaller heaters more for "Appearance/abeyance" not function. Also make sure the heater your looking at does not need electric to work. IF it has a remote then it will not burn without electric. The house I bought off my father has a fireplace that has a remote and you have to have 110 volt electric for it to lite/burn. The controls are electronic. The ones I like are all mechanical. Capillary tube type thermostat.
The one that where most common where made by DESA International. That company went broke. Some of it's brands/designs where bought and are being manufactured.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
