Posted by UP Oliver on March 15, 2017 at 20:30:08 from (68.70.134.87):
Hello.
Thanks to all that gave me advice a few days ago with regard to my electric motor shaft. I got the thing to stay in one place, but I can't get the motor to work for more than an hour or so. I think it gets too hot and shuts off, even though it is in the same exact spot and hooked up just like it was before.
The shaft does not slide out like it did before, I would say for sure I have less than a sixteenth of an inch of play that way. The shaft rotates nicely I think, but I really think the bearings are completely shot. I can grab the end of the shaft and it moves back and forth (sideways) too much in my opinion.
My questions are about that bearing, if that is what I got there. There is a bushing there, and then this velvet material which some video stated was there to hold the oil that I am supposed to put in there. I can't believe they make that anymore, or do they? Is that a bearing there? Is there something I can install there that does not need oil? A new bearing?
I would have more information but I don't want to take it apart beyond repair.
Any help or information on how this thing works is appreciated.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.