Posted by 550Doug on May 10, 2017 at 15:30:49 from (23.239.41.228):
I bought a tap & die set years ago and haven't really had a need to use it, until today.I have a piece of 3/4 inch partially threaded rod in which I had to extend the thread another 2 inches. So I went to this tap & die set and found a die labeled as 3/4 NC10. I put it on the existing thread and BINGO, it fits. So I proceed to cut about 2 inches of extra thread. I do a few passes and then test with a nut. The nut of course runs over the original thread nicely but it stops at the new thread. It will not thread onto the new threads even with elbow grease.
So I looked at the original threads and they seem to have a sharp point where as the new threads have a rounder top profile. Then I checked the die more closely and found the word Tungsten M20 2.5 and then it dawned on me that this die might be METRIC!!
If that is the case is there anything that can be done to get the correct threading?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
