Posted by Determined on September 07, 2017 at 16:30:03 from (216.130.212.248):
Went to fire up The old Ford dump truck today, ran great as always but when I moved it I noticed the clutch was releasing right near the top.
Too many people learning to drive a big truck around here but that's the way it tends to be on a farm.
Anyways I have adjusted more clutches than I can count over the years and they all have been the remove the lock arm and turn the ring style or the push in and turn bolt style.
This one has me puzzled I have not seen one like it before and I could not find one like it in my heavy truck books going back to the 60's.
It is a dual disc clutch behind a Cat 3208 with a 13 speed tranny.
There is no lock bar nor is there a push and turn bolt on it.
What it does have is 3 spots that have a lock plate held on with a couple of 5/16 bolts, protruding through the center is a nut with maybe 1/4 - 1/2 inch of threads sticking out, the nut takes a 13/16 wrench.
I blocked the pedal down then turned the engine over to access each of these nuts one at a time.
First I tried tightening the nuts 1/2 turn each, this made things worse.
Next I backed off each of them the initial 1/2 turn plus an additional 3/4 turn.
Tried it and the pedal is now releasing about mid stroke, good enough for what it is.
Likely what I was adjusting was the release finger pivots so even though I did my best to turn them all equally I can't help but think these should probably be set with a feeler gauge with the clutch released for a proper setting.
If anybody out there is familiar with this set up and is is willing to share some tips or knowledge it would be greatly appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.