I have used or owned numerous trailers and here is my two cents worth. H&H with hydraulic cylinder that you jack up the front of the trailer to drove on; my least favorite, couldn't get rid of it soon enough. Electric hydraulic lift with push button up and down; better but still a pain unless someone is there to help you. Alumina and other manual tilt with a cylinder that you open and close a valve to allow the bed to go up or down; better than either of the other two but the only time I use the valve is loading two smaller items where you load one and don't want the bed to go down until you load the other. May not be what you are looking at but I don't like a trailer where the deck isn't level after you load the tractor. I don't trust the brake locks on the tractor and can't always shut the tractor off. Also hard to use with a winch. I only want a flat deck over with beaver tail and ramps. As a side note, I always thought Dexter axels were the only way to go. My latest 2 year old PJ with 12,000 axels has been nothing but trouble. Axels weren't lined up properly and ruined 4 tires, Brake pads came off one wheel and almost ruined the hub. All wheel seals leak so much I have to refill the oil for every long trip. Neither PJ or Dexter will pay for any of the repairs. Don't trust that a new trailer was built right.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.