Posted by Paul in MN on November 30, 2017 at 08:55:56 from (65.128.233.63):
In Reply to: split tractor posted by grizz02 on November 29, 2017 at 19:06:15:
I haven't split this model, but son and I have split 9000 and TW10 with cabs and AC to replace clutches. In both cases, we used a homemade rectangular welded box like support beneath the cast engine oil pan. The splitting stand was fitted with commercial scaffold wheels and used 2X wood pieces at the top to make contact with the oil pan casting. We did need to separate the power steering lines and brake lines, but not the AC lines. The cab stays with the rear section. We rolled the engine section forward about 12" and that gave enough room to change the clutch parts and pull the flywheel if it needs resurfacing. I made a clutch plate alignment tool on my lathe which helps it go together much easier. We welded up the splitting "box" frame and finished the split by noon of the same day. I hope your loader is a quick detach model so you can get it out of the way easily. Be sure to wedge the front bolster against the axle housing before the actual split so the engine can not rock sideways. Take a lot of pictures for reference when reassembling.
Good luck, work carefully and know that it can be done (even on a dirt floor with a couple sheets of plywood).
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
