Your wording is a little confusing about what you have tried the ...set in 3rd.. is what I don’t understand so I am not sure if you had the tractor out in motion. As others have said get it out in the open and make sure you remember to give some room to stop because your going to have to shut off the engine to stop. Let it idle a bit so the engine is somewhat at operating temp. Then shut it off place it in 2nd gear and start the engine. Rev the engine up and get moving. Then deaccelerate and shift to third. Now get up to 3/4 throttle then start rocking the throttle as you say up and down to create sort of a ...bucking bronco... motion. All through these steps the clutch should be held or blocked down. Applying some brake as you raise the engine rpm may be helpful but let off them when you are deaccelerating the engine. I really don’t see what stepping on one brake at a time as Mike suggested would add to the outcome of this other than adding to the challenge of controlling the tractor. I realize it worked for him but I suspect the clutch would have came loose just as well if he had used both brakes. Good luck and above all be safe.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.