I am a dummy when it comes to things like that but I have been able to take a Delco distributor completely apart and clean and put back together working. A distributor has to have a switch with wire in from battery and out to distributor. Too many years to remember just how things are hooked up there. If a Wico distributor throw away and replace with a Delco. Wico could not be repaired 40 years ago. On a mag Deere never put a switch on them. Sepposed to stop them by shetting fuel off, chocking or like we did, idle as slow as possible, put in high gear and apply both brakes and partially engauge clutch. Could be if you knew what to do be hooked to a switch to stop and it would be a one wire grounded switch like the IH Farmall had. If you had to use a normal 2 wire switch one was hooked to mag and the other was to place on dash where switch was mounted. Allis used a shorting strip on the mag.. I don't know of anybody in last 40 years that actually new what to do to work on a mag. I go to the Portland, Indiana tractor show every year and they usually have one or two mag repair on site venders there. Might just might be one for either the spring or fall swap meets. But then if you depend on it and have to wait a year to find one of those places you are stuck. Most anybody can figure out a Delco distributor.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.