Posted by MikeJM on February 21, 2020 at 04:14:34 from (174.201.0.41):
In Reply to: JD 3020 engine swap hi posted by Burro2190 on February 20, 2020 at 09:26:45:
Burro,
Since you have 4 engines to work with I would pick the one in the best condition that starts the best, the 329 would be low on my list as they are notorious hard starters.
Your project will be a little more difficult since your lengthening the tractor. Have you considered trading an engine for a 4 cylinder?
You will need a rear engine adapter and the front pump support from a 4030. You will also have to have someone competent modify the flywheel to fit and pilot on a spacer that will have to be fabricated to move the flywheel rearward .500". This is the real critical step, it is very important that the spacer run true and the flywheel is rebalanced after modifying.
Also, you will have to figure out which water pump to use because the big one on the 6 cylinder won t line up with the radiator.
I also imagine you will need to use a set of 4020 frame rails to start with and modify those. Maybe you could use 4030 frame rails too, I m not sure about those.
And it is understood that you will have to lengthen hydraulic lines and some wiring and do something with the hood.
What you ll be putting together is basically a dry clutch synchro 4030 or a power shift. It ll basically be an Argentine 3420.
My little 239T puts out 115 hp on my dyno with absolutely no smoke. It s a stout nimble little tractor.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
