Mark B, I don't blame you for fixing up your Trek. A nice old steel bike is worth saving and riding. Anyway, in the past I worked part time in a bike shop as a mechanic for a few years and one thing we ALWAYS did to a new bike and one in for work/tuneup is to check the alignment of the dropouts, front and rear. They need to be parallel. If they are not it can set up stresses that will cause a dropout to crack/break and put strain on the axle. And make the quick release mechanism seem mushy. Any good shop can align them in about a minute with tools that clamp into the dropouts, shows alignment, and allows them to be bent into alignment. I bring this up as you have spread the rear triangle to allow a wider hub, (a common and acceptable practice), and if this wasn't done your dropouts will not be right. And not all shops do this as a regular thing. The higher the quality of the bike the more likely it is to be right from the factory but the quality level isn't a guarantee, they ALL need to be checked when new. At least that was the way it was 20 or so years ago. Suspension forks other suspension components are an exception as some you would to bend. Possibly you are aware of this as you seem into it. Enjoy your USA Trek.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
