Posted by FarmingEngineer on October 18, 2020 at 11:48:25 from (73.96.106.162):
In Reply to: 06 f150 heat issue posted by Plowhand on October 17, 2020 at 08:14:14:
On the automatic heater controls like yours, the Electronic Automatic Temperature Control (EATC) module has adaptive memory where it stores calibration data about the actuators. This can be reset by removing power to the module for 1 minute. When it is repowered, it will recalibrate itself. The official procedure is to remove the connector from the EATC module for 1 minute but I don't see why you couldn't just remove the battery cable for a minute and step on the brake pedal to discharge any caps just like if you were clearing the PCM adaptive memory. Keep in mind that disconnecting the battery will clear the PCM's adaptive memory as well. The EATC module is up kinda behind the glove box in the dash. Not sure if resetting the EATC could help but it might.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.