Posted by bc on February 11, 2021 at 18:20:07 from (24.255.129.137):
In Reply to: JD BACKHOE SNOW BLADE posted by lenray on February 11, 2021 at 10:05:49:
I put a 3 point set up on my front bucket so I could move bales too. If your bucket has a cutter bar on the front then it has bolt holes in place. Take a piece of 3/8" or 1/2" by 3" flat bar about 4 or 5 foot long so you can get a few bolts holes to line up. Then weld a couple pad eyes on the flat bar for the 3 point pins and a couple pad eyes on top of the bucket to put a top link pin in there. To mount the bottom of the 3 point bale spear I spread the pad eyes wider than normal so I could slide one side in, remove the bolted pin from the other side, slide the pin in and then screw the nut back tite. Might be a better way with a quick hitch setup for the pins but that is how I did it. The flat bar sits back far enough that it doesn't interfere with moving dirt and the pad eyes don't affect anything either. Leave it on all the time. If I remember, I can get a pic tomorrow if you want one. Come to think of it, I never welded the pad eyes on top, just used a chain.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
