I will assume 430 is same as 530 just smaller. When you start the bale throttle your tractor to 1000-1200 rpm. Once you have a 16 inch bale in it then throttle up and away you go. Be sure you are not hanging any hay out the side of the pickup at the start, it will plug every time. I try to stay center of swath to start.
I am not sure of what type of hay you are trying to bale but if slippery grass you may have to go early morning or late evening when it has a little moisture on it.
as for speed, once the bale has started you can go 6-8 MPH. Just remember that if you get to far over the swath that it hangs up on the edge of the pickup it will plug again.
Double check if it plugs again that the belt that turns the pickup is not slipping( might be just a clutch and chain no belt, been a few years.) That belt has to be tight.
I have made 10s of thousands of bales with 530 and 535.
Low RPM and not hanging over the edge of pickup and you can bale anything. I have been told that when the belts are to wore down you can have way more problems. should have 2 steps minimum on the diamonds of the belts.
One trick others have told me with wore out belts is to have a spray bottle with coke in it and give the belts a spray as soon as you kick out a bale just before starting again. I have never done it but some say it makes the belts sticky and every few bales is all it takes.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.