Posted by super99 on February 11, 2023 at 15:59:11 from (184.20.235.0):
I haven't posted on this yet, right or wrong, here's where I'm at on it. The old tach has over 5000 hours on it and the new one that was on it when I got it has 125 hours( in 2 years). It used quite a bit of oil and had lots of blow by, so I figured it needed rings, bearings and a valve job. A few warm days in February and I got the motor out on the stand and started tear down. The head is off, you can wiggle the valve springs, so the guides probably need replaced. I took the head to a place I trust to check it out. There is NO ring groove in the sleeves, smooth as a baby's butt where the pistons stop travel, but there is a vertical scratch on 4 sleeves. I got the pistons out and those 4 had the top ring broke in 2 pieces, so I figure the scratch is where the broken ends rubbed the cylinder wall. I took the rod caps off and all of them have a brown spot on one side of the bearing, some bigger than others. I took the 2 center main bearings out and they are the same way, the thrust bearing appears to have a spot worn clear thru the bearing itself. I'm thinking that I need to have the block line bored and the rods checked. I'm trying to do this cheaply as possible. It only does tractor rides, shows, a couple plow days and piddle around home some, I can't see spending lots of unnecessary dollars on it for no more than it does. If it was a working tractor then I could see it. I have a wood project for my granddaughters birthday next weekend that I have to finish before I get back on the motor. Chris
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.