Thanks for all the replies. Jargon has never been my strength. I was using a multimeter. I had it grounded at the negative battery post. I could make the outside floods work by powering it through a different pin. I forgot to mention the upper circuit breaker would drop voltage on one half at the same time the pin would. I know enough about electricity to either be useful or dangerous, just depends... I think I have enough to run some tests tomorrow morning and report back. Just fyi, the white connector in the picture is currently brand new with all new wires going to new bulbs. I used those pictures to show brillman what I needed to make sure I recieved the right harness. Another detail I left out is the remaining pins I have to choose from don't seem to have power in all three positions. I have a hunch my switch is bad. If anyone knew the for sure way that connector is supposed to be fed that would be a big help. For example, top left pin feeds brights, etc. Me and my MULTIMETER,have deducted my current configuration. I'll use your guys tips and get back to you. Again, thanks for the replies, forums like this are priceless.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
