Tractor Talk Discussion Board |
Re: Pole barn
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve from Tn on November 30, 2003 at 05:49:22 from (208.128.241.8):
In Reply to: Pole barn posted by Slofr8 on November 29, 2003 at 19:39:54:
I am building a pole barn and learning as I go. A couple of suggestions. Treated 4X4's are about $25 each. Of course, 4X6's are a little higher. We put them in the ground with a bag of redi-mix around each pole. I believe we put a 4X6 every 12 feet and a 4X4 on each side of every door. The other thing is to make the length and width in multiples of 3. The metal sheets are 3 feet wide and it works out better this way. One more thing: keep it square. An old-timer is helping me and guiding me. He is 81 and I had to make him get off the roof and let me drive those screws in. I hope I do half as well at that age. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|