Tractor Talk Discussion Board |
Re: Re: Pole barn
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian G. NY on November 30, 2003 at 07:14:08 from (64.246.154.163):
In Reply to: Re: Pole barn posted by bob on November 29, 2003 at 22:05:56:
Aspen (Poplar) makes good inside window trim! Not strong enuf for structural work. I agree about using PT for everything in contact with the ground. When setting poles, dig holes below expected frost depth for your area, drop an unopened bag of "Redi-Mix" in bottom of hole and set pole ON it. It's a good idea to drill a hole and insert a piece of 1/2" rebar thru the bottom of pole allowing it to protrude 6" on each side. Spread a bag of "Redi-Mix" around pole covering the rod. Not a good idea to surround the rest of the pole with concrete; more likely to cause rot and will crack and separate from pole anyway if you're in frost prone area. Backfill with soil around poles and tamp well every six inches or so as you do it. Unless you're in an extremely dry area, there is no need to even soak the "Redi-Mix" as it will cure from natural moisture in soil. My 2 cents; based on how Morton Buildings did mine; they have built a lot of them. BTW,use highly treated poles. Morton used 8 lbs. per Cu Ft Cromated Copper Arsenate (Type III) on mine. I know there are changes being made in the treatment used for PT lumber, so check with your local lumber supplier.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|