Tractor Talk Discussion Board |
Re: CRANKCASE BLOWBY
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tommy D6-8U on August 21, 2004 at 18:14:50 from (209.198.52.55):
In Reply to: CRANKCASE BLOWBY posted by NEED HELP.......... on August 20, 2004 at 18:39:20:
I run a fair amount of engines on our dynamometer at work and even with rebuilt engines run at various loads, you will almost always get a fair amount of what looks like excessive blowby. When you actually measure it with the manometer, its only an inch or so of water column. All mfrs figures are different. The first engine I rebuilt myself did fine until I put the 100% load on it and it steamed out the vent like a locomotive for about 5 minutes and then cleared up. It was a 1004 Perkins; I think they say about 2-3 inches is acceptable (not sure about that). All told, I"ve dyno"d Perkins, Kubota, Deutz, Nissan, Yanmar, JD and they all seem to do about the same; it always looks worse than it is. For what its worth! Tommy
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|