Tractor Talk Discussion Board |
Re: Engine rebuilding 4020 john deere
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by New-Gen on September 27, 2004 at 21:31:06 from (4.158.6.232):
In Reply to: Engine rebuilding 4020 john deere posted by Steve Heier on September 27, 2004 at 17:13:48:
The best place in the long run to get the parts is your local John Deere dealer. They aren't that much more expensive than most aftermarket parts and they tend to be better quality. If your friend is familiar with diesel engines the two of you shouldn't have much trouble overhauling your tractor. 4020 engines are pretty basic. One crucial thing is to make sure you get the O-ring grooves in the block where the liner drops down SPOTLESS, otherwise you might leak coolant into the crankcase. Get yourself a service manual, the original John Deere one is the best, but I&T has one too, either one will give you all the specs on clearances, capacities, bolt tourques, ets. The tractor serial# is at the back ot the rear end housing, that's all you need for ordering parts. Good luck! NG
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|