Tractor Talk Discussion Board |
Re: Backhoe Hydraulic Cooler Removal
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by NC Wayne on October 12, 2004 at 20:42:24 from (205.188.117.10):
In Reply to: Backhoe Hydraulic Cooler Removal posted by AndrewS on October 12, 2004 at 06:56:51:
Like one post said typically the thin nut is actually soldered to the cooler and is used to prevent twisting off the cooler leg while the wider one should swivel around the line. One secret I've found over the years that works great on hydraulic fittings is this. Now depending on how stiff the cooler legs are you might have to use something as a back up device, but take a hammer or a hammer and punch and give the swivel nut several good hard whacks on a couple of the flats. I've seen #32 fittings that wouldn't budge with a wrench and a cheater pipe break loose with the wrench alone after a couple of good solid hits. Like the old saying goes when all else fails get a bigger hammer...in this case though it actually works. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|