Tractor Talk Discussion Board |
Re: cheap way to fix pto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on June 21, 2007 at 18:12:57 from (24.224.246.156):
In Reply to: Re: cheap way to fix pto posted by ford1971 on June 21, 2007 at 14:48:37:
NewHolland dealers ought to carry that sleeve. It's been 15 years since I bought one, and I think it was less than 10 bucks then... However, I doubt that will work. That's a big jump to make. The shafts that I've seen worn out actually wear the leading edge of the splines off from torque. They don't reduce their diameter. Their "fit" just becomes loose until both the shaft and coupler get worn, and then the lighter couplers will spin on the shaft. You can try the adapter sleeve if 10 bucks is nothing to you, but I'm reasonably certain it won't go on. The OD on your shaft is still going to be very close to 1-3/8".... Rod
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|