Tractor Talk Discussion Board |
Re: Why does it make noise?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mac on July 17, 2005 at 06:19:29 from (217.144.243.200):
In Reply to: Why does it make noise? posted by kenojoe on July 16, 2005 at 04:33:37:
Sorry John, as former owner of a constant mesh TO bearing, I agree with Joe to a point.There's a teflon thingamajig spacer to protect TO bearing on some of these 85series(IH74/84 kin, not Case) that wears out. Check your pedal height spec in manual(there isn't any freeplay in this type setup). It's probable the spacer is gone and TO bearing isn't riding fully on carrier. causing the rumble until clutch is pushed and seats bearing again. It will get to a point where fingers or bearing face will wear out and clutch R&R is needed, even though disc is still good. I went back with freeplay setup where spring holds pedal and TO back like 74series so I get full usage of disc.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|