Tractor Talk Discussion Board |
Re: Tractor loading ramp
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by someone used my name on June 15, 2006 at 19:01:08 from (204.227.221.148):
In Reply to: Tractor loading ramp posted by Lourens on June 15, 2006 at 04:12:56:
Hi Lourens, I just built a set almost exactly as you describe. Mine are 16" wide, 9'4" long. I used 3" channel on each side (can't remember the pounds/ft, but it is the heaviest 3") and used 2" x 2" x 1/4" angle for the cross pieces on 10" centers with 3" channel for the bottom cross piece. I mounted the angle with the flanges resting on the lower flange of the channel (inverted "V") I've since used them to load a Bobcat S220 which is about the same weight range you mention. There was no noticeable flex in the ramps while loading. The ramps are heavy, but I can easily handle them alone. I'll try to get a pic & post when I get a chance. HTH, Regards, DL
Replies:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|