Tractor Talk Discussion Board |
Re: Freeze the balls off a brass monkey?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Joe (Wa) on August 09, 2006 at 00:27:36 from (67.5.134.79):
In Reply to: Re: Freeze the balls off a brass monkey? posted by sammy the RED on August 08, 2006 at 19:21:55:
Sea story AKA "this is no sh!t" Most sailing ships had a cannon for protection. Cannon of the times required round iron cannonballs. Ready use cannonballs were stacked in a square-based pyramid next to the cannon. The top level of the stack had one ball, the next level down had four, the next had nine, the next had sixteen, and so on. Four levels would provide a stack of 30 cannonballs. The only real problem was how to keep the bottom level from sliding out from under the weight of the higher levels. To do this, they devised a small brass plate ("brass monkey") with one rounded indentation for each cannonball in the bottom layer. Brass was used so the cannonballs wouldn't rust to the brass monkey. Due the difference in metal composition and mass, the brass contracted in size faster than the iron. As it got cold on the gun decks, the indentations in the brass monkey would get smaller than the iron cannonballs they were holding. If the temperature got cold enough, the bottom layer would pop out of the indentations spilling the entire pyramid over the deck. Thus it was, quite literally, "cold enough to freeze the balls off a brass monkey."
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|