Tractor Talk Discussion Board |
Re: Seating bead on rear tire
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A Gusta on November 27, 2006 at 18:52:20 from (74.37.91.119):
In Reply to: Seating bead on rear tire posted by super99 on November 27, 2006 at 16:51:44:
A tire needing the bead seated, and especially if being stubborn, should be done in a "cage" device. I have done(many years ago)on a tire road service used a clip on tire chuck and a couple of extension hoses. With the two hoses disconnected from each other, clipped on a clip on air chuck on the wheel, then halfway to the compressor connected the two hoses at a coupler, inflated from a distance till bead seated, or I felt I had enough air in it, then uncoupled quick connector and allowed to deflate before nearing it again. You can also add a pressure regulator in the equasion if you desire to set a limit.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|