Tractor Talk Discussion Board |
Howse 6' bush hog (washer holding bell to shaft)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David Lee Hawkins on May 13, 2007 at 14:13:43 from (66.19.112.57):
There is some kind of washer with multiple teeth that slips around the shaft of my Howse 6' bush hog. The bell housing with the blades attached go onto that shaft and the nut/washer tightens it all down. The shaft has teeth cut into it on the end that fade smooth about an inch and a half up the shaft. I am missing the washer that fits on the shaft. The blades and the bell shaped disk slip around the shaft easily. The person I purchased the tractor from had tack welded the bell shaped disk to the mower shaft. That is a bad idea and I would like to fix it correctly. Where can I get one of these washers? Is there an alternative solution? Thanks, David Hawkins
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|