Posted by John T on December 26, 2007 at 09:47:20 from (66.244.83.147):
In Reply to: Re: 12 volt front coil posted by georgeky on December 26, 2007 at 09:14:28:
George, Actually, there are indeed 6 VOLT COILS and then there are 12 VOLT COILS and NOT ALL coils, therefore, are 6 volt. Heres the difference:
6 VOLT COIL
Has around 1.5 ohms of low voltage primary winding resistance as measured between its lil + and - terminals.
It is engineered and designed for ONLY 6 volts use and 12 volts would cause it to overheat plus the points would burn up quickly from switching excess current!!!!
12 VOLT COIL
Has around 3 ohms of primary coil/winding resistance as measured between its lil + and - terminals and is designed to have 12 volts (NOT 6) applied across its terminals.
If you were to only use 6 volts it will have a weak spark !!!!!
Although some refer to them as being "internally ballasted" most (slight exceptions) achieve their higher 3 ohms of primary resistance by use of more turns or length of primary coil windings OR ELSE they could use higher resistance wire.
One reason for 6 volt coils to have only 1.5 ohms of low voltage primary winding resistance while a 12 volt coil has twice that (around 3 ohms) is to limit the amount of current necessary for the points to switch to around 4 amps to avoid premature burning.
If you wish to use a 6 volt coil on a 12 volt tractor you can add an external series voltage dropping (12 to 6) ballast resistor so the coil only sees 6 volts plus the current the poinst have to switch is again reduced/limited to around 4 amps to avoid premature burning. One advantage of such a system is so the externally ballasted system (NOT so if theres no external resistor as on a 12 volt coil) can by by passed during start up to improve cold weather starting.
Hope this helps yall understand the 6 volt and 12 volt coil thing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
