Posted by ScottyHOMEy on February 27, 2008 at 20:40:27 from (71.241.213.254):
In Reply to: b farmall wide frt ? posted by none needed on February 27, 2008 at 20:16:54:
Not from the factory.
Most you see like this are either As with longer differential shaft and housing put on the left (making them more like the width of a BN) or Bs that have had a wide front (from an A or elsewhere) mounted up.
Things for your friend to check are the chassis serial number (On a plate on the inside of the left seat support). If it's there, the prefix of the serial number will tell you what the tactor started life as, esecially if the numeric part of the ser# matches the # on the engine (on the block, just below the number one plug, kinda obscured by the throttle control link to the governor). The chassis # should start with FA. The third position will be the model #, as in FAA or FAB (or even FABN in the case of a BN). He should also look to see if the wide front is centered on the tractor. Also, on a true B, the right-hand seat support, looking from the rear, is mounted to a bracket on the seat support so that there is a gap of several inches between the seat support and the fender. On As and BNs, the right-hand support is mounted to the final drive, so that there is very little room between.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.