Posted by DickL on August 28, 2008 at 09:09:13 from (76.76.33.112):
All B's, C's and CA's front endes bolt to the front of the block with 1/2 inch studs. I knew they were wrong when Hillbilly was saying he couldn't figure out why he was having so much trouble getting the nuts off. The CA block is taped for 5/8 inch threads but a stepped stud was used from the 5/8 inch course thread down to the 1/2 inch fine thread. The holes thru the fronts are for a 1/2 inch stud. Yours would have been drilled out. Check your B they should be correct. Were the studs removed from the block you received from me? If they were you will find that a 1/2 bold will screw in. The front of the block on that C was broke out on one stud. That is probly the reason. You really need a new/different block for that one as well to correct those problems. You could get threaded rod to put in the old holes and drill and tap them to the 1/2 inch. With the front being drilled out larger you would have some room to be slightly off center but not much.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.