I think your white smoke is caused by unburnt fuel , did you change the pump setting at each degree setting 19,25,30. if you didn't there is no wonder it is pigrooting.its fueling and firing are not synchronized. Find out the degrees of timing, I understand the FSM is a 5000 in USA and fires at 21 degrees but don't take that as true. Bring the No 1 cylinder to TDC [top dead centre] on compression stroke [you may have to remove the rocker cover to observe the valves] the flywheel tdc mark should correspond with the pointer on housing, move the flywheel back to 21 deg. The timing mark on the fuel injection pump drive coupling flange should then be exactly aligned with the mark on pointer attached to pump, adjustment can be made by loosening the cap screws on coupling. If you want to check take pipe off no 1 at pump and turn motor by hand, pump should spurt at the degrees btdc. This applies to a FSM so the principle would be the same with your motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.