Tractor Talk Discussion Board |
Re: 6 or 12 volt coil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by snitkawl on October 05, 2000 at 04:50:13 from (64.216.158.40):
In Reply to: 6 or 12 volt coil posted by hunter on October 04, 2000 at 17:46:08:
The resistor goes in the wire between the ignition switch and the coil. The purpose is to cut the voltage back to 6.7v to prevent burning the points. Most ignitions have some method to use 12v to start then switch to the wire with the resistor to run. Most use the start soleniod to accompolish this. It seems that on these old Fords tho, that they start fine on 6.7v. I have no idea where the notion of using a 6v coil when switching to 12v system came from. I had never heard of it until I started reading posts on this forum.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|