Posted by paul on October 30, 2009 at 08:09:01 from (76.77.197.242):
In Reply to: Grinder mixer posted by 4 bottem on October 30, 2009 at 05:40:24:
When I went to National FFA convention back in the day, they took us on a feed mill tour. We got to stand on the catwalks, and look sdown on the main electric motor that ran the main hammer mill. They said it was direct 4000v lines running the motor, you could see the thick rods that were the main power line into the motor.
Was very impressive.
My 50/55 Gehl mill is comfortable with a 35 hp tractor on it, but I have to feed it slow with ear corn. Would probably do better with 50-75 hp running it.
As the others say, it works, but I doubt you have the setup to make it go in a timely fashion. Unless you can tie into your main electric feed before the transformer? (Just kidding....)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.