after too many bad investments, I finally bot a used Bandit 6 inch chipper with hydralic feed from rental yard, 25hp Kohler, feed opening is 6x12 so crotches feed more often, I keep strong loppers nearby for bigger ones, Vermeer is 6x6 so lot more trimming needed
after bringing the knives/anvil and feed wheel back to spec it chips everything I ask it to including dry elm, very knarly thornapple and fenceposts with barbed wire attached (oops)
unit has rpm sensor to stop feed as engine loads down then restarts it when engine comes back, you can do same thing manually with feed bar, thats how a 25hp engine works on this machine
old time drum style needs enuf power to chip the whole piece, no way to stop the feed
I had 6 inch Woods hand feed before this, great for 2x4's or straight pine but useless on the kind of wood I have to chip
PTO units eliminate engine headaches including mouse infestations and gas gumming up the carb, some units use tractor hydralics to run power feed, other have own pump/tank but cost dearly
some people stack the brush then rent machine for a day, if machine is taken care of and is available when you need it then this is best way to go, too many rental yards neglect the knives
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.