jdemaris said: (quoted from post at 20:36:41 01/06/10) Yeah, this sounds like a stupid question, and I've had plenty of experience rebuilding engines.
Here's my problem. I've got a Ferguson TO35 engine torn apart and am trying to do an "in-frame" motor job. This all began because a sleeve was leaking coolant into the oil pan.
Engine is the Continental Z134 gas. So, I pulled the pistons and rods out and the rod bearings are all marked .020. So, that's an easy one - .020" undersize bearings. But, the mains have no such numbers. Just FM2227 SB. So, I assume FM is for Federal Mogul. I can't find a listing for that number in any database. I had originally thought that maybe the "SB" stood for standard bearing?" But, now, I'm not sure. Bearings looked good and I was just going to reuse them - so it didn't matter. But, just checked and they've got .0035" clearance (too much). So now I want new ones and can't figure if they're standard or some undersize that is NOT stamped on the bearing. I can't get a mike onto the crank journal while it's still in the tractor. I did attempt a crude measurement with calipers and tape measure and with this very poor measurement - the crank journal seems to be around 1/32" smaller then standard. That could easily be .020" or .030" under.
So, at this point, I have no idea what bearings go get. Anybody ever come across an undersize main bearing that was not marked undersize?
Why is .0035 clearance too much? Sounds about right to me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.