Posted by msb on February 22, 2010 at 19:50:47 from (67.236.244.190):
In Reply to: 4010 JD Overhaul posted by Rick Weller on February 22, 2010 at 19:05:49:
Its unusual for oil to come from the weep holes. It is usually antifreeze that leaks first. You can do a much better job if you pull the engine. Its always a good idea to replace the rear crankshaft seal so you have to split the tractor to do that and it doesn"t take much more work to pull the block out. I like power wash the block once the sleeves are removed and then it is easy to turn the block over and wash the bottom side as well. You cannot roll the camshaft bearing out. He must have meant to say roll the main bearings out which you can do.
Clean the o-ring groves out and look for pitting. If you are careful, any pitts can be repaired with JB Weld.Just be sure the groves are smooth when repaired.
I am more than a bit particular about overhauls(lol) and I make it a practice to run a tap in ALL holes and clean all bolts on a wire wheel. Take a look at the oil pump drive gear on the camshaft. If the teeth are sharp. it is a good idea to replace the cam and the oil pump drive shaft.
If you just want it to stop leaking, you can chance it and simply plug the weep holes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.